Discussion:
Got Fuel Gauge Wires out of 2002 Lowrider Gas Tank
(too old to reply)
Manjo
2012-08-16 22:02:09 UTC
Permalink
Raw Message
My thaks for the two gas tank schematics. They were right on.

Turns out the wires run down through a tube in the gas tank that keeps the wires from getting soked in gas.

I pulled the wires out the bottom.

I'm now trying to pull the two pins (12 V and grd) out of the AMP MULTITECH 2-pin connector using the directions in the Lowrider HD manual.

I can't seem to free either pin using the manual's directions.

Anyone done this? Is there a write-up or some guide as to how to free the two pins? I need to replace the old chewed-up wires with new ones.

THanks,

Manjo
Jeff
2012-08-18 13:52:52 UTC
Permalink
Raw Message
Post by Manjo
My thaks for the two gas tank schematics. They were right on.
Turns out the wires run down through a tube in the gas tank that keeps
the wires from getting soked in gas.
I pulled the wires out the bottom.
I'm now trying to pull the two pins (12 V and grd) out of the AMP
MULTITECH 2-pin connector using the directions in the Lowrider HD
manual.
I can't seem to free either pin using the manual's directions.
Anyone done this? Is there a write-up or some guide as to how to free
the two pins? I need to replace the old chewed-up wires with new ones.
THanks,
Manjo
http://mael.rivoal.free.fr/Manuel%20Buell%20XB9R/sm_appb1.pdf

Basically you stick a small tool into the connector alongside the terminal to
depress the tang to unlock it and hold it there while pulling out the wire.
Loading...